Hauler & Hermann
Insulation Parts for Battery Modules: Shields, Covers, Die-Cut Parts

Applications

Insulation Parts for Battery Modules: Shields, Covers, Die-Cut Parts

Custom shields, covers and die-cut parts for conductive components in battery modules, many of them self-adhesive.

Applications

Which insulation parts we make for battery modules

Hauler & Hermann makes custom electrical shields, covers and die-cut parts for conductive components in battery modules. The geometry comes from the customer, because every module is built differently. We build the cutting tool for it, from the first sample to series production.

Self-adhesive, on a peel-off release liner

Many parts need to be self-adhesive. We process films that already carry an adhesive coating, or we laminate standard insulation films with double-sided tape ourselves. We then cut the contour and supply the parts on a peel-off release liner.

For automated lines we can also supply self-adhesive parts kiss-cut on rolls: the parts stay on the carrier tape at a defined pitch and in the same orientation. The video on our die-cut parts page shows what this looks like in our production.

Materials: PET, Nomex, Kapton and PEEK

Materials include PET film, Nomex aramid paper including the 414 and 418 variants, Kapton polyimide film and PEEK. The right material depends on the requirements for flame retardancy, temperature resistance and dielectric strength.

Test requirements: UL 94 V-0, temperature, dielectric strength

Our customers focus on flame retardancy, often to UL 94 V-0, temperature resistance and dielectric strength.

For self-adhesive parts, suitability and classification have to be verified for the actual material build-up, adhesive layer included. The rating of the film alone does not automatically cover the bonded part. What the ratings mean is explained in UL 94 for insulation parts.

From sample to series

We supply samples from a quantity of one. For samples and small quantities a steel rule die is usually enough, typically costing €200 to €600. For large series and tight tolerances we build a solid steel tool in our own tool shop. How a sample is made without a production tool is covered in samples and prototypes from a quantity of one.

What we need for an enquiry

Send us the drawing or CAD data of the contour and name the material or the required properties. Tell us whether the part should be self-adhesive and whether you need it loose or on rolls. Add the quantities and we will send a quotation. Write to us via the contact form.

Do you have an application in mind?

Describe your installation situation and we will check feasibility.

Frequently Asked Questions About Battery Module Insulation

Which insulation parts does Hauler & Hermann make for battery modules?

Custom electrical shields, covers and die-cut parts for conductive components in battery modules. Many of them are supplied self-adhesive on a peel-off release liner.

Which materials are used to insulate battery modules?

Among others PET, Nomex including the 414 and 418 variants, Kapton and PEEK. The right material depends on the requirements for flame retardancy, temperature and dielectric strength.

Does the UL 94 rating of the film also apply to the self-adhesive part?

Not automatically. Suitability and classification have to be verified for the actual material build-up, adhesive layer included.

Are the parts available on rolls?

Yes. With kiss-cutting the parts stay in a defined position on the carrier tape, which is supplied wound on a roll. This pays off mainly when an automated line picks the parts from the tape.

From what quantity do you make insulation parts for battery modules?

From a quantity of one. Samples are usually made with a steel rule die, and for series production we build a solid steel tool in our own tool shop where needed.